Practical seminar which trains first-time users to be able to use the electric cylinder 「ROBO Cylinder」 within a short time.
Completely Free
ROBO Cylinder Experiencing Seminar Currently Accepting Participants
Concerning the free experiencing seminar
"Low cost manufacturing" is the common quest for all manufacturing industries, but the current held cost reducing methods does not show any outstanding effects against such quests. This seminar is a practical seminar which trains a first-time user to use the key to cost reduction・efficiency increasing, the electric cylinder 『ROBO Cylinder』, which is implemented in large number of production lines.
The seminar teaches the practical information such as the examples of ROBO Cylinder installations, cost reducing・energy saving effects and controlling procedure of the actual model.
The seminar is completely free of charges, nothing will be charged against our customer. Once the number is met, the application will be closed. Please apply as soon as possible if you have any interest on participation.
ROBO Cylinder Seminar Course Menu
Installation course and application course, both of them are available in ROBO Cylinder Experiencing Seminar, allowing participants to attend the seminar which suits their depth of undestanding, which may range from first-time users up to those who can use them to an extent. Please inquire our office, or dealing companies for seminar contents, time・venue. Seminar can be applied through our home page any time. Please use this occasion to apply.
Installation Course ~ROBO Cylinder Experiencing Seminar
Teaches you the operation method on the spot.
Target |
Those who have participated in MEC Experiencing Seminar, or those who has basic knowledge about ROBO Cylinders |
---|---|
Lecture Contents |
|
Application Course ~ROBO Cylinder Experiencing Seminar
Teaches you a higher level of ROBO Cylinder application methods.
Recommended for electrical engineers |
Target | Those who have received lectures in ROBO Cylinder Experiencing Seminar(Installation Course), or those who have used ROBO Cylinder before, and knows the basic PLC sequences. |
---|---|---|
Lecture Contents | (Required time Approximately 5 hours) 【1】PIO wiring procedure(Practical:Uses the PLC) 【2】Basic sequence controlling method 【3】Network(Gateway Unit) 【4】Serial Communication |
|
Recommended for mechanical engineers |
Target | Mechanical engineers, those who are involved in production engineerings, those who received lecture for maintenance in ROBO Cylinder Experiencing Seminar(Installation Course), or those who have used ROBO Cylinders |
Lecture Contents | (Required time Approximately 5 hours) 【1】Model Selection(Practices on practical examples) 【2】Introduction of Examples of Problems 【3】Maintenance 【4】Troubleshooting |