Product feature
Attachment orientation
Main specification
| Heading | Contents | ||
|---|---|---|---|
| Lead | Ball screw lead (mm) | 6 | |
| Vertical | Payload (Note 5) | Max. load capacity (kg) (Power saving disabled) | 10 |
| Speed/ Acceleration/Deceleration | Maximum speed (mm/s) | 225 | |
| Minimum speed (mm/s) | 8 | ||
| Rated acceleration/deceleration (G) | 1 | ||
| Maximum acceleration/deceleration (G) | 1 | ||
| Stroke (mm) | 50 | ||
(Note 5) Assuming a speed of 225mm/s and an acceleration/deceleration of 1G.
(Note) The maximum payload is a guideline for the weight of the stopper jig.
| Heading | Contents |
|---|---|
| Drive system | Ball screw φ10mm, rolled C10 |
| Accuracy of Repeating Positioning. | ±0.15mm |
| Lost motion | - (Can't be indicated because this is a 2-point positioning function. ) |
| Rod | Φ25mm Material: Hard alumite treated aluminum |
| Guide shaft | S45C |
| Front bracket | Material: White alumite treated aluminum |
| Ambient operating temperature and humidity | 0 - 40℃, RH 85% and below (no condensation) |
| Protection grade | IP20 |
| Vibration resistant/Shock resistant | 4.9m/s2 |
| Compatible to overseas standards | CE mark, RoHS compliant |
| Motor type | Pulse motor (□42) (power capacity: Max. 4.2A) |
| Encoder type | Incremental |
| Encoder pulse No. | 800 pulse/rev |
| Delivery | Written in [Reference for delivery] section of the homepage |
Adaptive controller
(Note) EC series has their controller built-in themselves. See page 2 769 for details of the built-in controller.
Oversea specification
Important notes on selection
 | (1) Please use it only as a stopper. We do not recommend using it for any other purpose. (2) The home position is set on the opposite side of the motor. Please check the dimensional drawing for the home position. (3) Thrust from conveyors, etc. (lateral load) must be limited to an allowable load of 500N or less. |
Dimension drawing
ST： Stroke
M.E.： Mechanical end
S.E.： Stroke end
(Note) The rod moves to the M.E. upon returning to origin, so please take precaution that it may not interfere with anything while the returning process is running.
(Note) Grease nipple for applying grease is not installed.
(Note) There is no oil filler port for the ball screw.
Mass
| Stroke | 50 |
|---|---|
| Mass (kg) | 3.8 |
Correlation diagram of work mass and work collision speed
(*1) When using, please ensure that the length of L is 50mm or less.
(*2) Thrust from conveyors, etc. must be limited to an allowable load of 500N or less.
